Al Ko Kober HDM 850

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Chessel

New member
Joined
21 Jan 2020
Messages
1
Reaction score
0
Location
Kirkbymoorside
Can anyone help me? The belt on this lathe has just failed and manufacturer’s spares don’t seem to available anymore.
What generic belt is suitable? The failed belt is 450mm outside diameter 8mm wide, 8mm deep
 
That’s an unusual belt, one that I’ve not come across before. A standard SPZ belt is 10mm wide and 8mm deep, which is what it might be, Belts after prolonged use stretch and get thinner, so it could be 10x8 rather than 8x8. Usually on the belt somewhere will be what it is, I.e. SPZxxx it’s also an unusually short length. Again I’m not aware of a standard belt that is that length. If it’s 450 internal length it could be a SPZ 487
 

Latest posts

Back
Top