6 IN PVC DUCTING

[user 19915]

H'i can you recommend somewhere i can buy 6 inch pvc pipe for ducting plus the 90/ degree bends and drop offs down to 4 inch white preferable ??? Mock

 

[blackrodd]

This maybe what you're after http://www.tlc-direct.co.uk/Main_Index/ ... oCKWfw_wcB
You had better check that all the fittings are available!
HTH Regards Rodders

 

[dzj]

If possible avoid 90 deg. bends.

 

[Myfordman]

160mm drain pipe big enough? All the usual fittings widely available.

 

[blackrodd]

Or as MM just said drain/soil pipe, http://www.drainageonline.co.uk/Drainag ... ttings.htm

Probably cheaper, but not white as requested in the op.
Regards Rodders

 

[user 19915]

Thank's white would be nice but drainage pipe would be o'k . Does it make a difference with the blast gates plastic or metal and again where do you think i can get them ebay ??
mock

 

[blackrodd]

I've not checked prices, there's these, http://www.amazon.co.uk/diameter-woodwo ... B00BSWR4U8
Or these, http://www.ductstore.co.uk/acatalog/Bla ... mpers.html
http://www.bakers.net.au/part/06592845/ ... g-160mm-id
Regards Rodders
PS.
I would think that some members have recently found similar fittings at competitive prices.

 

[user 19915]

I'm also thinking of dropping down from 160mm x 110mm Triple Socket Reducing Drain Branch 45dg down to my tools ?

 

[user 19915]

Sorry to keep on about ducting but a quick question ?Instead of a blank end on the ducting can i use a blast gate at the furthest end of my garage as a blank end and use on occasions with a flexi pipe ???
mock

 

[CHJ]

If the blast gate is on the far end of a run and of a suitably firm fit so that it will stay put at an intermediate position then it can be used to let air bleed into the large duct to increase the air volume flow to help entrain debris if you are experiencing fall out in the duct because of insufficient flow from smaller inlet points.