Hello,
Ive made a built-in ply wardrobe and finally managed to get 8x drawers made but now comes time to installing them but I've never done it before so I am not 100% sure on the best way to make sure everything is spaced correctly and level.
There are 2 carcass each with 1x small draw and 3x larger at around 800mm wide (a bit wide I know).
I am using concealed full extension Blum draw sliders.
They will all have false fronts that I would like inset/flush with the front.
I was looking to buy the Kreg jig but I hear its not that great for heavier draws.
Any step by method, tips or great videos that explain it all would be great as the few I have found haven't been that helpful :/
Cheers
A
Ive made a built-in ply wardrobe and finally managed to get 8x drawers made but now comes time to installing them but I've never done it before so I am not 100% sure on the best way to make sure everything is spaced correctly and level.
There are 2 carcass each with 1x small draw and 3x larger at around 800mm wide (a bit wide I know).
I am using concealed full extension Blum draw sliders.
They will all have false fronts that I would like inset/flush with the front.
I was looking to buy the Kreg jig but I hear its not that great for heavier draws.
Any step by method, tips or great videos that explain it all would be great as the few I have found haven't been that helpful :/
Cheers
A