Search results

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. B

    Elektra Beckum HC260 problem

    Should read “following yours”
  2. B

    Elektra Beckum HC260 problem

    The feed fllowngyours has offered a pdf copy but thank you for your kind offer
  3. B

    Elektra Beckum HC260 problem

    That would be great thanks. I appreciate your help
  4. B

    Elektra Beckum HC260 problem

    Thanks for the reply i’m trying to find step by step instruction on how to set the tables, I’ve cleaned and greased the I feed channels but I’m struggling to get them dead level with each other.
  5. B

    Elektra Beckum HC260 problem

    Elektra Beckum HC260 Apologies if this is posted in the incorrect category. Problems with this planer which I am very experienced with. Planing and edging timber which is 1metre in length I end up with a cut which is concave over the entire length to the tune of about 1mm at each end. Any...
  6. B

    Electra Beckum HC260 Jointing problem

    Hi H Thanks for the info and video I was using a straight edge but will try the methods shown in the video and report back
  7. B

    Electra Beckum HC260 Jointing problem

    Hi R over 16 inches it butts for the first 2 ins then there’s a gap of about 3 ins then it butts for about 6 ins then a gap for the remainder
  8. B

    Electra Beckum HC260 Jointing problem

    H. Could you elaborate please
  9. B

    Electra Beckum HC260 Jointing problem

    Thanks for the reply i’ve had a straight edge between the beds and the largest gapi can find is .002“ I’ve set the blades to .005” above the outfeed table but still no success. The machine used to produce very good joints but I had to change the blades as the old ones were nicked and I sadly had...
  10. B

    Electra Beckum HC260 Jointing problem

    Hi I,m new to this site and wonder if anyone can give me some advice. i,m having trouble jointing using the above planer the joint has high and low spots and as it’s for musical instrument they need to be perfect. i,ve levelled the beds reset the blades but the problem still persists and I,very...
Back
Top