Search results

Hello Probably been asked b4. Can anyone recommend a combination Mig Tig welding machine. The guy at Stahlwerk in the EU won't trade with us anymore but does have one with plasma also. TP

Anyone know where to get single Vee pulleys blank centres or small hole. I want to reduce a motor 1400 rpm to 350 rpm with 4-1 pulley ratio. Maybe around a 50mm motor pulley to a 200mm dia driven pulley. Any advice very greatful. Taul Paul

Does anyone know the actual general wheel RPM on a 4 1/2" angle grinder. I've seen 10 000 mentioned but I find it hard to believe. Plan is to use one as a motor power source but I can't if it runs at that speed. TP

Eyup peeps Probably going to line myself up for a load of criticism but here we go. Bought the old tired Wilson vice a few weeks ago. Just as a keep me busy project. Loved going thru it and bringing it back to new look life. All the bits to the right of the mic are the old bits that were made...

Hello Does anyone know if BSW deep head screws can be bought? Or have I got to make them. 5/16" BSW thread, just under 1/2" AF and 3/8" deep. Ta

Hello UKW First post. I saw this vice and thought it was interesting, and they are, so I bought it. I've looked at others but most are smaller. This is the 6" version and quite un-molested. Its in bits already. The plan is to re-make the rear jaw pivot, install fresh guide bars, make a new front...

Hello Workshop folk 1st Q is to ask if this forum is just woodworking? on signing up I thought I’d seen engineering stuff. TP