Search results

Never thought about that ;)

yes very smooth, used some thick grease on the thread that tales away any chatter. With the thread pitch being 2mm a quarter of a turn is 0.5mm in height so fairly accurate as well. As can be seen in the photo just setting up some “T-Track” for the fence, not yet finished.

Yes all the functions still work

Wanted a rise and fall router table for a while but could not justify the exorbitant cost. So came up with this. The guides were 12mm so I tapped one side M14, old guide still fits if I need to revert any time; and it works a treat. Perhaps does not look as pretty as one that cost £100’s...

I have been trying to get my better half to fill the kettle just after it has boiled, so the water gets to room temp ready for the next brew and thus save electricity; or so I thought ! Last night I measured 2 pints of water into the kettle and left overnight. The next morning I timed it to...

Many thanks for all the advice above. Using the formulae above supplied by Sandyn I calculate I need 11.7kW Therefore the smaller heaters are not powerful enough. So the heater described in my original post a the head of this thread seems to be ideal. Unfortunately I have not seen any posts...

The IR heater I have gas so not able to fit thermostat

Thanks was going to use Red Diesel is that the same ?

Evening workshop approximately 10m x 10m with pitched roof Cheers Dave

Greeting, This is my first post since joining 2 days ago; hope you can help. I have tried gas space heaters put found them very noisy, they heat up the workshop really quickly but keep have to switch it off and on again or I melt. A couple of weeks ago I bought a gas infrared heater, noise...