Search results

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. biker_smith

    Naerok mill - cutting out

    Hi all, I've had my Naerok mill about a year now and have been using it for light work, mainly ali. Since I have had it I have had the same issue - in that it cuts out while taking a cut. I then have to wait about a minute and the then it seems to reset inself and then starts up again. It seems...
  2. biker_smith

    Light for Milling Machine

    Hi - I'm after a light / lamp that I can screw to the wall next to my milling machine to help me with the use of it. Thanks - Paul.
  3. biker_smith

    Startrite Mercury Pillar Drill - motor pulley

    Hi all, I fitted a new motor to my Startrite Pillar Drill, but had to bore out the centre shaft hole as the new motor shaft had a larger diameter. Long story short - I need a new drive motor pulley! Its has five speeds - largest diameter is 128mm and the total height is 66mm. Can someone tell me...
  4. biker_smith

    CPX Carbide Inserts - holder required

    Hi all, I just bought a bunch of CPX carbide inserts today at an autojumble, to use on my Colchester Bantam lathe, in the hope that I had the correct holder at home. But I don't, can someone please tell me what is the correct holder I need and the best place to buy in the UK? Many thanks - Paul.
  5. biker_smith

    CPX CARBIDE INSERTS - holder required

    Hi all, I bought a bunch of CPX carbide inserts at an autojumble today, to use on my Colchester Bantam lathe, in the hope that I would have the correct holder for them at home. But I don't - can someone please tell me what holder I need to buy and the best place? Many thanks - Paul.
  6. biker_smith

    Naerok Milling Machine

    Hi all, Finally got my Naerok mill delivered yesterday, so now busy having a look around it. Unfortuntely it did not come with any instruction manual or parts book - so what's the best place for these or does anyone have a pdf (or photocopy) they could share with me please? Thanks - Paul.
  7. biker_smith

    NAEROK milling machine

    Hi all, I've just bought a NAEROK milling machine and need to get it moved. Can anyone tell me please - what's the approximate weight? Description and photos at..... http://www.lathes.co.uk/naerok-mill-drill/ Many thanks - Paul.
  8. biker_smith

    Startrite Mercury Pillar Drill - no power

    Hi all, I bought this drill a few months ago and soon after I started using it I noticed its lack of power. It stalls out under very little load (my drilling is mainly metal work - not wood) and I can stall the chuck just by gripping it with my hand. Today I've removed the motor with the...
Back
Top