Search results

I have a table saw, quite old acquired from family and wanted to enquire about some parts - the machine is model Scheppach TKU article 51350000. I need the RIVING KNIFE ASSEMBLY WITH FIXING PARTS - the complete ITEM 1 as shown in the attached parts manual page in the red square. Can you advise...

Thanks MikeJhn for your input. Unfortunately the screws are not reachable either as I just cheked...the head of the screws remains barely visible from underneath the outfeed table with the blades at top dead centre...I really wonder how no thought was given to this or else I am not getting this...

Thanks for your encouranging words...appreciate your help

This is really of help Fitz and greatly appreciate the time you took to shoot the video. I have basically done the same thing to set them up and without the spring it takes a significant length of time...and patience. I managed about a 2mm difference in movement of vertical line on the wood...

the ebay ones I managed to try a set before getting the machine to my garage...but in view of screws becoming under the outfeed table they are of no use as when the magnet holds the knife at top dead centre I cannot access the screws unfortunately.

Ok noted and will try with end screws only. I came across this product...do you think it is something that would be useable in my emco? https://www.advancedmachinery.co.uk/mac ... system-382

you mean machine holes in the outfeed table directly above the screws? wouldn't that affect the wood going out on the table when planing if in case the edge of the woods gets caught in the hole?

If i leave the blades all down they drop quite far with the tip not showing from the spindle. The fourth screw is behind the fence that is why it is not visible.

Thanks for that and I had managed to find that manual. So I have understood that it is going to be trial and error and hopefully by experience I can get to reduce the setting time. Just to confirm, the blades have four screws. You advise to hand tighten the ones at the ends and adjust that...

Thanks to all for reply. The video is great and I can understand the method. The only thing is that since the screw heads come below the outfeed table when the blades are top dead centre, I cannot manage to screw the blades in the final position without turning the spindle to expose more of...

Hello, first post here.  During last xmas I acquired a planer model Emco Rex B-20.  The owner had passed away some months back and I got the machine with a set of blades installed and a set of spare blades. The machine works great. Now I have some spare time, took the blades for sharpening...