Search results

Was cleaning up an Axe head today had to grind the poll with my 9 inch grinder with a flap wheel on it producing lots of sparks I’ve been storing a roll of super fine wire wool under a near by 10 mm ply shelf near my work bench for ease of use, so cleaned the axe head and didn’t think...

Any one here know of a supplier in bulk rather than small packets of 5 etc Stone Tool Shop use too but don't now

Excellent quality restored and used Union Jubilee wood turning lathe See photos for overall condition and type, it is very good condition, it came to me just over a year ago in quite a poor state, it had been standing it an old workshop for over 20 years unused. Its been used by myself...

Managed to get a good deal on eBay on one of these would recommend fantastic pice of comfortable kit for turning, sanding and any other dusty work Was more than my cheap graduate but well worth it

I have a Sealey 8 inch bench grinder, when using it today together with dust extraction etc it tripped electrics in my workshop I reset the trip and tried it tripped again so confirming it’s the grinder that’s gone puff, I’ve not had a chance to look at it yet but thinking it’s going to be...

I have just got hold of one of these and just changed my 3ph 240 v motor over from my jubilee so I have variable speed a pain to do but worth I also swapped some cheap castors I had on the jubilee but have found they are not the best as only 3 on main base and of course a lot heavier I need...

Hi all see photos attached with the knowledge here anyone recognize what it is I have been told its a barge axe but cannot find anything on the interweb to confirm this The only similar looking thing I can find is a Whale flensing blade Its marked I believe to be Long lane and Smith the...

My metabo BAS 317 precision band saw is starting to show its limitations for the works I'm using it for these days Consequently I'm possibly in the market for a bigger or better machine for reasonable monies in the above area or possibly further afield for the right machine Was thinking...

I have a Union Jubilee lathe - I’ve replaced the bearings etc and new 3 p 1 hp motor running through a inverter with variable speed all works well and enjoying learning how to wood turn mainly tool handles at the moment - looking at more complicated work later The lathe was free - I restored...

As above undamaged cracked etc don’t mind some a bit of restoration if rusty for reasonable monies please can collect West Sussex, Hampshire, Surrey areas

I picked this up over the weekend it needs a new handle Any ideas

Any body know what this tool is ? Assuming it a turning chisel but not sure

Good quality Parkinson perfect 15 vice In good condition, will need a clean and surface rust removal, looks to have had light use £ 70 delivered or £ 50 collected Chichester West Sussex

I have a pal with some old wood working machines in an old workshop all 3 phase that have not been used for many years Just sounding out if they would be of any interest would need to be all together as access is difficult a timber wall would have to be dismantled and re-elected or dismantled...

Hi anyone here know this Kent pattern axe makers mark

I have just been given the above its not a duel voltage type motor I have been doing lots of searches on here and found lots of very good information, but its a little out of date with links that don't work etc Anyway I'm looking for the best way forward 1. Replace the motor with a new one...

I have just brought a second hand machine needs the above, clamps and dust bags might anybody have any of these laying about not needed anymore

Long shot I’m after a cast Ali (trunnion?)bed support and fence also

Any one tried this if so how did you go about it

Not sure what this is the handle is high quality thought it was toilet chain handle at 1st but on close inspection it has the same makers name -Townsend Hereford it’s needs sharpening and it appears that you pull it