Hi all,
I recently acquired a 3 phase 352. I've taken out the old three-phase, 1hp motor and ordered a new 1.5hp, single phase motor. Can anyone tell me if the old switches (pictured) built into the machine will still work?
Thanks
Josh
Little problem:
As soon as the wood clears my infeed rollers, it stops dead. Strange thing is, the outfeed rollers still seem to be touching the wood. They're just spinning on it. If I pull the wood through manually the outfeed rollers drop a little bit when the wood clears them.
The outfeed...
I have been running my PT (Sedgwick PT255), table saw and router on my Yorkleen WV2. This is a 2000W twin motor machine similar to the Record DX4000 or the Camvac twin. It handles the waste quite well but after reading the Bill Pentz stuff I am starting to think I should invest in a system with...
I'm about to replace my existing mask. To date I have been using the 3m-4251 and replacing every few months. I'd now like to buy one where I can simply replace the filters when needed.
I have been looking at the 3M 6000 range but can't decide between half mask (6300) and full mask (6800). Is...