Search results

The numbers match up, but what's the chances of them actually fitting snug? Also not sure how deep of a dado to make in MDF? many thanks

Oxfordshire

Hi all, I'm looking for some cost-effective advice regarding two different types of finishes. My project is a coat stand roughly speaking four legs about 6 foot high. before I buy the wood, I'm considering what finished to use and the cost. What wood is good for painting over, googling it...

That's what I was thinking but I want the slats to be smooth , so its a no go.

Hi, I know this is basic , but I have always used screws with a greater depth and haven't worried about it. I am using teak (repurposing an old teak garden table, into a duckboard) and I want to screw from 12.5mm into 8mm slats. What kind of screw should I be using to give the most strength...

you star, thank you I was starting to think I imagined it .

Hi, I know this will sound silly but, I feel very uncomfortable purchasing any wood I have no idea what I should be paying , prices are always on inquiry. Does anyone have any resources on what to expect to pay for different wood? Many thanks

Hi all, I have been away. But I greatly appreciate all the input. Many thanks

Hi All, I recently bought my self a very old MULTICO table saw. Its an old British company long since gone. So old its in imperial but is a lovely big slab of cast iron . Its a bit of a project piece for me which I hope to bring up to modern standards on a side issue advice welcome. But...

Hi, I am fairly new to woodworking and I am struggling to find a good supplier. Has anyone had a good experience with an internet lumber supplier? If so who? Or any Oxfordshire recommendations? Many thanks