Search results

If you are thinking about the 'two halves' route you could put a thin batten along the joining edge that over laps each side by say 50 mm. Attach it to one half before it is erected first, then run some sealant along it before raising the second side. as you fix the second side you'll seal the...

I've just made a new front door for a listed building. It faces south and continually gets all the weather. The old one had had various coats of Dulux etc on a regular basis but always faked and cracked within a few years and the door and frame rotted as a result. I did a bit of looking around...

As a matter of interest would you put two blast gates on a table saw, 1 off the back, the other off the guard. and if so, would opening them both cause a problem assuming that you had switches on both gates?

Brilliant, just what I needed, thanks for your patience with an electrical zombie!

So I've opened up the DX and found a JD3 switch inside (marked B, 'A' is the mains intake). I take it that it is this that needs replacing, possibly with something like this maybe? 353069420908 from the bay

That's great, thanks for that Sheptonphil. Do the microswitches have to be a particular size then? I see these microswitches on the same site as the relay

Its a Axminster Hobby FM300BC

I too have a plug and play system, I hang the controller from the roof on a cord in the middle of my small workshop. The problem I have is that of starting the vac up. My Axminster vac has to be started at the machine in the corner of room as I don't quite know how to make it permanently 'on'...

Thanks Bob, much appreciated. ;-)

Hello All on here. I'm a newbie looking for the exact same manual (DW3401). If its still available, could someone send me a copy please? In particular, I'm looking for the length of the blade so I can get a new one. Thanks in advance.