Search results

When I saw the title of this thread the first thing that sprung to mind was the wife!

Here's a video i watched a couple of years back on the very same subject.

Portal Can i have some cake?

I would print them at 45 deg so no supports needing to be generated and the layers would run diagonally giving maximum strength in all directions. You would need to enlarge the chamfer on the top a bit and draw in a simple triangle support on the design to support it on the bed to stop it...

Try disabling any ad blocking software on that page. Gerry

The wifes credit card.

The knurled wheel isn't found on all calipers, even my sylvac pros doesn't have one and they are premium calipers. https://www.machine-dro.co.uk/sylvac-s-cal-pro-30-910-9502-digital-caliper-range-150mm-resolution-0-001mm-ip67

Not all calipers have them and the same rule of thumb applies to use a consistant number ot turns to try and give an equal pressure between measurements. Gerry

Digital calipers are usualy within a +/- 0.02mm tolerance but so much depends on your "feel" for the pressure you exert on the measured piece. Having said that about calipers I have a set of sylvac pros which do measure to 0.001mm but they are very expensive and I believe the only ones available...

I would love an electric car as I usually do short local journeys but I don't have off street parking and although the car is parked next to the house it's across 20m of public green and the main footpath. There are no windows or doors on that gable end of the house and I wouldn't feel...

If you don't group them then they are seperate models. Gerry

The Rock In the 70's it was always Those Magnificent Men in their Flying Machines Gerry

Onshape, Free and online. Easy to use, Fully featured and loads of tutorials on youtube. Gerry

Model Diesel fuel and castor oil burning in a Glow motor. Gerry

Arduino Nano and just ask chat GPT or google Bard to write it for you. As said above simple to do just using Delay() Gerry

Check the insulating segments on the comutator are not standing proud of the copper segments. If they are you will need to undercut them slightly which you can do by hand using a bit of hacksaw blade. Gerry

I always silicone the edges but i always lift the pan out too and lino under it as if it wasn't there. Waterproof and safe. Gerry

There is still just as much oil in gas shocks the gas cylinder inside acts as a spring assistor. Gerry

Yes that boils my p!ss. I don't begrudge a penny of aid to those thast need it but they have a neuclear weapons program too. Gerry

Old brake fluid is great but my go to penetrating solution is 50/50 old engine oil and diesel. All it has to do is be thin enough to whick into the joint and provide lubrication. Gerry