Search results

Sold

It is still for sale, but unfortunately due to a toxic divorce I can't get access to my workshop. I'll post when I have it in hand. Yes the ducting has gone.

Thank you, I really appreciate that right now, unfortunately going through a very messy divorce 🙏

5HP Single Phase HEPA Bill Pentz design Cyclone Dust Extractor. Built by myself using Bill Pentz design Dust Collection Research - Home Genuine Clear Vue Cyclones 16" 6 Blade Welded Steel Impeller. 5hp 3ph motor with Yashkawa 1ph to 3ph Inverter *Needs min 32 amp Type 'C' supply* £500 -...

Mostly 150mm with 125mm & 100mm £150 - Collect from Cardiff

Building sash windows is a straight forward affair. I bought a Victorian house in 1997 that needed 22 replacement windows, I bought a book and dismantled an old one then renewed all of them with draft excluders etc. Saved a small fortune :)

Beautiful

I actually bought from www.hyvlar.se/en before Brexit but they don't seem stock Sjöbergs any more... Be aware there are 2 models of this vice: 1) Sjobergs Front Vice For 33110 Bench Top that Axminster sell https://www.axminstertools.com/sjobergs-front-vice-for-33110-bench-top-105721...

Total cost... Timber £420 T-track £78 Sjöbergs Vice £190

Bravo (y)

Part 9: Applying finish, T-track & dog holes to the top

Part 8: Base construction I wanted to be able to transport the bench in the future if needs be so I decided to glue each side of the bench together with dominos. They would then be held together with cross members that had dominos and pocket hole screws and the top placed with small dominos for...

Part 7: Top construction I put the DF700 to good use along with 160mm wood coach screws to hold the top components together.

Part 6: Preparing the timber I processed the timber down to manageable sizes on my bandsaw, then laminated pieces together. I had put off building the workbench until my new Hammer A3-31 Planner/Thicknesser had arrived. I thought it would be a good project to test it out and it performed...

Part 5 : Timber selection Originally I had planed to construct the bench out of European Beech, similar to Sjöbergs benches but I found Beech to be in very short supply at the timber merchants, I only managed to get a few small planks, certainly not enough to make the whole bench. European...

Part 4: Fusion 360 Design First Attempt: Final Version: Fusion 360 Render:

Part 3: Initial Design I use Fusion 360 for final design but I still like to use Sketchup in the initial phase of a project as its super quick to come up with ideas. Workshop Layout: First idea with tool tray: Final Sketchup design before moving to Fusion 360:

Part 2: Gathering Ideas I wanted to design a bench to accommodate the CTM 26 underneath and be approximately 1800mm x 600mm. I studied the ‘The Workbench Design Book’ The Art & Philosophy of Building Better Benches by Christopher Schwarz, Chris notes in his book that rule no.1 is ‘Always...

Part 1: Introduction. I have been planning to build a new workbench for some time. I have been working on a makeshift assembly table that I made 5 years ago to build my new kitchen. I joined 2 MTF tops from eBay length wise, resting on trestles. This was prior to building my new workshop 2...

Great Job Mike