Search results

well my wood is in the garage until i put the finishing oil on in the house when its complete, but with this it was in the house for a couple of days before i did the resin so i was surprised it shrank really, although it was on the table by a radiator so that might be how it dried out more...

I used resin to attach 6mm thick quartz crystal with a tourmaline surround but the wood has cupped and cracked the crystals does anyone think its just the resin that caused this as the 2.5 inch solid ash is kiln dried wood is normally ok without the crystals ?

ok I think I will attempt this week and let ya all know thanks again

I got to do it in one hit really so as not to have anything show through as the quartz is quite clear and hexagonal in 3rows of 3, yeah ill post photo ...if successful other wise bin and sulk haha cheers

yeah I'll have a little think about the size issue,, thanks for all the advice, these places are amazing as I don't have anyone else to ask so great stuff people

thanks all arr yeah I was gonna use masking tape for any over spill as I was worried the finishing oil seeps in and ruins any bonding and yeah a slight undercut sounds good, also can you leave it to cure for a little while befor I plant the crystal discs ontop so they don't sink down ?

ok thanks for the advice all, well I have a large single garage and I think any table saw is gonna take up room, just a quick one are they ok using for cross cutting with the slding table bit, saves getting a mitre saw as well

hello all I'm gong to rout out some ash wood and inset some quartz crystal discs about 7 mm deep surrounded by a 6 mm border of some black mineral chips, using clear epoxy surface resin but not covering the crystals, does anyone know if this will stick to the wood and stay stuck, any ideas...

Hello all does anyone have advice about the axminstar t200 or t250 table saw, this will be my first one so don't know if its worth getting the more expensive one or not, I don't do a lot of work just some at home after the day job but I do buy sawn wavy edge timber and cut it and plane it to...