Search results

an angle grinder to cut the blade , which will need to be held in a vice to tame the long end

Hi Rich, I have a TS200 that I bought and never used , has the extended bed and foot but not the sliding table. Its in near Twyford Berkshire so not too far away if you are interested.

As the quantity of material is low it might be worth using tricoya , miles better than marine ply for the application.

Part of what drives the pain killer epidemic in the USA is the health care system, if you cannot afford the insurance payments , or do not have benefits from your employer you are stuck, so instead of treating your problem with a fix , you keep pushing it away with another type of fix and that...

Hand powered are fine if you only need to do 5 rivets , after 10 they are a pain and after that ,,, , there are two styles of air gun , one has the air canister at the bottom and one looks like an air impact gun, a friend works a lot on horse boxes and trailers that use a lot of rivets ...

This is not a plug for a company I worked for nearly 40 years ago , but they are still going and have springs from stock of all kinds + a lot of info about them https://www.leespring.co.uk/uk_compress ... hat=Search They may be expensive but they did used to cater for small orders and I...

Will buy Wood turning items bundle please

we setup air points using tap fixings from the following ebay seller: https://www.ebay.co.uk/itm/Outside-Tap- ... 0290.m3507 using flexible hose to connect between and adaptors to connect the hose , thats in a car garage and works well with the largest diameter flexible hose. Flexi hose tied...

This depends on what you use the air for, blow gun and nailer/brad/stapler then you don`t need anything with high capacity or a dryer, you can use decent rubber hose and clip it under benches it is really cheap in 10m lengths . If you want to run sanders, spray gun , then its unlikely that...

You are more likely to damage the pulley - crack it where the legs sit , put some packing in to spread the load and give the pulley hub a good 3 minute heat up with a blowlamp or heat gun before winding it off.

do not mess with it if its brand new , I do not remember anything different with mine with the plunge action compared with any other plunge saw, certainly the Mafell feels and functions in a more robust manner than the others but only in a reassuring way

Pro flight cases for music gear most certainly cannot get away with bodge fasteners , everything is pop rivet , wood to alu to steel , best stuff has steel washers on the back sides. I recently re-sized a flight case by removing the rivets and track sawing right through the ply and alu...

I have dials and digitals - better digitals are less likely to have battery issues, dials are great but watch out for sawdust and chips - they have tiny rack and pinion that can get contaminated . For the modest price digital is most practical , M&W good price/quality , Mitutoyo get faked so...

PM sent

sending pm ideal for me

sending pm ideal for me

Things to note about the Festool vacs , and general points: The motors are Domel or similar - most vacs use the same/similar The hoses are very tough high quality but expensive, the tapered rubber end is great as it fits a variety of tools. Variable speed is very handy for sanders and is...

Would like to buy the router plunge base please if still available ?

I have one on my Bambi BB50D - it makes a phut=hiss as per settings , I have it set quite frequent as the compressor is not in daily use and imho more excersise is good for it, I want the compressor heads to get good and hot to discourage condensation in the motors. Watch out where you point...

Yes please - sending PM