Search results

finally got there. Its 17mm if you use a spanner for changing bike pedals, it is thin enough to fit int h gap between the blade holder and cutter block can get form amazon Thanks to all Rod

Thanks very much Steve. It's actually M12 not M8 in the manual. My typo Does 16mm spanner sound right? Thanks for your help Rod

thanks very much Rodders My mistake I meant M12 you are right Hopefully an owner can provide some more info best wishes Rod

Grateful for any advice about blade setting for my newly acquired Wadkin BAOS planer thicknesser. Fortunately it came with the blade setting tool, but no spanner for blade adjustment. Please can anyone tell me what size spanner I need to undo the bolts which hold the blades in place? I...

Grateful for any advice about blade setting for my newly acquired Wadkin BAOS planer thicknesser. Fortunately it cane with the blade setting tool, bit no spanner for blade adjustment. Please can anyone tell me what size spanner I need to undo the bolts which hold the blades in place? The...

For JMcK Just read this thread. I have Multico M1 morticer and would be very grateful if you could mail me the manual as you offered before to selly. I'm fairly new to UKW so can't PM yet. Not sure how it works, but grateful if you could contact me. Thanks v much Rod

Thanks to all. I was planning to remove the handle to clean the saw up, but following your advice I think I'll leave it alone! Thanks also for the advice about the age of the saw. I'll post a picture later.

I have two old Sheffield made backsaws (?1940s). The handles are attached with flat fronted brass screws into a split nut, which is very worn. How do you remove these other than drilling out please? Thanks for anyone's suggestions