Search results

Hi all, the Bosch GCM 12 GDL is currently on Amazon deal of the day for £575 delivered

Hi all. My thicknesses has started to leave this groove at the start of the run. Any ideas??

I opted for the Titan one (mainly because it was cheaper) The jointer face is square, and the fence is also square to the face. Have done a quick test and the results are really good. Haven't used the thicknesser yet. As for noise levels, its similar to my table saw and router table, so no...

Hi all I am looking for a relatively cheap planer, for my occasional DIY hobby. I have seen these 2 at screwfix, and in terms of board width these 2 are fine. http://www.screwfix.com/p/erbauer-erb05 ... 230v/81126 http://www.screwfix.com/p/titan-ttb579p ... 230v/15774 Does anybody have any...

there is no error, its just hanging in my outbox

Why cant i send PM's? Effective 21/01/2013 Ive sent in the past and i am active on the forum.

yeah, is the width of one of my chisels

Hi all All 4 legs squared up now My fist ever go at mortise and tennon

Saw blade is straight. Very simple to change, take safety guard off 1 screw. There's a plastic plate to take off 8 screws. Then just un bolt the blade. Riving knife stays in. Haven't used rip fence yet but I can say it's quite solid, it can be altered for alignment. Mitre guide slot has a little...

well ive just finished putting the saw together are gave it a test drive on the 4 legs to my end table made from oak and it was fine. Nice straight cut just what i wanted. The saw isn't noisy at all. All the parts seem to be well made (even the plastic parts) The saw sable for the one i got...

i will be cutting some small pieces of oak first. I am making a small end table for my conservatory. I was thinking of making a TV unit next, also for my conservatory. Surely this saw will be accurate enough for me as a general DIY man and some small ish projects. Im not a joiner/carpenter by...

This saw will only be getting used every now and again. If it's no good I'll send out back, but for what I'm using it for it shouldn't fail

How do u know this saw will not be suitable then? What saw should I be looking for?

Well I've just ordered Clarke CTS 10D 10 inch

Hi everyone. I am in the search for a new (rather, first) table saw. I am not really a heavy user but a table saw would come in very handy. I have started making small projects from oak. My budget is £200 I have looked at a few table saws, that being a Einhell a ryobi and a Clarke one. However...

Yes very pleased. Just started making a new end table for my conservatory. Gonna take me a while but keep me busy. Got some oak cut ofs from local timber yard for nowt to get me started

Hey thanks. The speakers are monitor audio br 2 bronze. They are on a wooden floor so they have felt on the bottom This is them all finished

I have managed to obtain some 2"x2" oak off cuts from the timber-yard now. :) waiting for a quote on some 1" boards then i can start to get the wheels into motion. I have just bought a new Triton MOF001 also, so i am looking to utilize this a lot on the project This is the 1st leg squared up...

Hi This is a new 1st proper project of mine. I am going to make a end table to go at the end of my new sofa in my sun room. The table will be made from oak of which i am going to purchase tomorrow from my local timber yard. Either oak plank or sleeper, is there any difference? The size of the...

Just bought the triton MOF001 £120 unopened from cash generator :)