Search results

Thanks for all the advice. That's great. I do hope to get one from Axminster but we'll have to see. Thanks. Mike

Thanks Tom, That would be much appreciated if you do come across it. I have sent a PM with my email address but also my postal address as I'd imagine a hard copy would be better if you don't mind sending it. I will happily pay for postage. Thanks, Mike

Hi I've just bought a second hand mj12-1600 mark 1 version but the riving knife is missing. Does anyone have this machine that I can have a full scale drawing/template of the riving knife please so I can potentially get one made if Axminster can't get hold of one for me. Cheers. Mike

Idigbo with sikkens exterior light oak finish?

Probably too late but could you plug them instead?

Very very lucky you didn't get pulled over! Think it's 1 metre sticking out the back before you need some sort of flag or I think flashing light these day!!! Or having someone smash into you by not seeing it. Anyway, enough digging you in the ribs. You got it home safe and sound, very well...

Space plugs space plugs space plugs. Get them in your life. Great for kitchen fitting and other bits and bobs. No need for the side panels of the cabinet to go all the way back then and no need to scribe around pipe work/electrics or the actual wall. I run a rebate into the sides and...

The Cardiff store is only 10 minutes away. Have had to limit myself to 1 visit a month or when I order over the phone and get it delivered in store. Don't mind paying a little more on smaller items but I shop around for higher end stuff. Their customer service in the Cardiff store is fantastic.

Or for a bit more you could use accoya

I use the tube part from a kitchen cabinet leg masking taped on then the end of my Henry Hoover hose slides on to that with an added bit of masking tape. Works fine for me and I use my domino and ts55's that way

Can you use a pocket hole jig for attaching the face frames? Building the whole lot out of MR MDF would be fine. Use concealed, soft-close hinges for the doors rather than butt hinges as well. Take a look at my Facebook business page under the alcove album for cabinets I've made from MRMDF...

On another note, Slovenia is a stunning country and has a lot going for it from the caves to lakes and (small) shore line. My wife and I drove round most of the country on holiday a while back with my 2 year old daughter. Highly recommended as a holiday destination winter or summer. I'm very...

And now we should get back to helping out the OP instead of all this doom and gloom.

Lovely. Well done. Now all you need to do is persuade the customer to have you build a nice rad cover for them

If it's been pre-finished by ikea it'll be a nightmare to take it off back to fresh timber! I did this for a customer and it was serious hard graft and took ages to get it all off! I really wouldn't recommend it unless you have a good quality ROS and good quality sand paper & shoulder and arm...

Perhaps Accoya. It'll last forever pretty much.

Or turn the work over and cut of the push stroke

Accoya

I agree. Don't think anyone was spouting any rubbish, just good advice.

Scam. Avoid like the plague. DO NOT SELL TO THEM! They'll pay, then get the cash returned to them. It's far too easy in afraid