Search results

I must post here a few words about my recent purchase of a Titan Sander from Screwfix at £20. What an excellent buy! :D Well made, feels quality and performs well. They even throw in a hole puncher for the sandpaper which allows the dust to be collected in the attached barrel at the back...

Can't see how you can make a hole in concrete without drilling sorry. :( Might have to look at alternative fixings like no nails etc.

Thanks Chem :D

Hi to all. I have just had my NVR switch fail on my trusty Rexon table saw (replaced the circuit board last time remember) :( and have been told this was down to dust getting into the switch. Therefore I need to sort out a dust extractor of some sort. Can anyone signpost me in the right...

UPDATE I purchased a new circuit board from RexonSpares at a cost of £38.60 :cry: :cry: and it works perfectly. =D> The blade starts up slowly and brakes when it turns off so the board is useful and is worth having if only to stop me being scared out of my wits turning the saw on. Hope...

Thanks bob

Going to get cracking on sourcing materials for my car port for my bungalow. I plan on having a 10 metre one made out of timber and 25 mm polycarbonate roof. Not quite sure what to use as posts though. Should I go with 3 x 3 wood or a metal pole or a plastic post? Anyone know who does metal...

I have bypassed the circuit board and .................................drum roll..............it works. =D> So it was a circuit board problem after all. I have spoken to a local engineer who thinks that the board is only to control the brake and that I can run it without the board. Think I...

I bought one of those and have been impressed with it but blowing it out made no difference. Going to bypass the board tomorrow and will let you know. My money is on the NVR switch #-o

I phoned the Rexon helpline and the technician seemed to think that it could be a circuit board problem. He is going to talk me through bypassing the NVR switch to see if the board does need replacing at a cost of £39. Wish I had a compressor to give the motor a good blow out as there did seem...

Hi fellas. Thanks Noel for moving to correct forum. i have to wait a few secs and then it will start again but pressing the red off switch seems to reset it for immediate restart. Will not stop on though when I try to cut anything.i

My Rexon table saw starts up ok but when you start cutting a piece of wood, it switches itself off. :( Has the NVR switch failed or is it ikely to be someting else. Thanks