Recent content by woodaxed

i use GM Imber they do a craft starter kit around £60 a year and 5 million http://www.gmisl.co.uk/site/products/cr ... e-starter/ Tel: 01342 327250 they are good and make it easy hth

cheers

cannot send a pm answer to a question from another member they as stuck in my outbox woodaxed

try turning your add blocker off when you get to the site ive had the same problem i set my add blocker to allow on the site and it worked fine

Im not a mechanic but spent a lot of time under cars years ago I wouldnt feel safe under that type of ramp youve got no side entrance or exit if something should go wrong your also not going to be able to reach tools or parts and your also blocking your own light and never do it on the grass...

I use 6mm mdf cut around the size of a lolly stick but cut the sides at an angle so you can get right into the corners i use spray mount to glue the sandpaper to it and if youve angled the sides you can use both sides or if you have no mdf or dont like it 6mm birch ply works well and lasts longer

thanks i use a 1/8" 14tpi thin blade 0.018" i get the blades from Dakin Flathers

variety in my designs makes them more unique so the posted pics are the same design but altered all made from american maple and walnut

theres a demo for scroll saws at axminster high wycombe tomorrow if she can get there http://www.axminster.co.uk/stores/high-wycombe/ its about 30 mins drive from bracknell

Im a long way from you so dont know the timber merchants there i use tyler hardwoods marlborough wiltshire, interesting timbers near shepton mallet somerset and goulden hardwoods between Andover and Newbury, Berkshire . tylers i get maple.ash and cherry normally a cube or more at a time...

i mainly 6mm round over cutter in a router table for rounding over on bandsaw boxes i would say that the dremel table is to narrow to do that with also your limited to what size cutters you can use.

axminster at high wycombe have a scrollsaw event on the 26 march if you can get there http://www.axminster.co.uk/stores/high-wycombe/

I use a belt sander and for the tight curves i use a lathe with 15mm dowel between centres with the velcro backed papers then finish by hand

thanks all

i thought i was specific by naming the paper Is there titan wet & dry sandpaper good quality