Recent content by Watsy

Just thought I'd share this as I'd been looking for alternative discs other than the fairly pricey worksharp discs. I came across this website http://www.abrasivesplus.com/epages/abrasivesplus.storefront/4f16e64f004d3f8827410a022f020581/Catalog/HOME and noticed they done the 150mm PSA silicon...

Quite often when I'm putting mitres together, I lay the piece down flat with the mitres touching edge to edge and put masking tape across the two pieces. Then I flip it over so that the V is exposed and run some glue along the joint. I then fold it together and the masking tape stops it from...

Couldn't add any more to previous post when I was typing it but any veneer with glue on it already usually came in the form of a roll of edging any time I used it. Often called "iron on edging." Was actually putting some 50mm stuff on today, would probably work well if you wanted to use it for...

Thecoder, no you don't need a press, you can use contact adhesive on veneers. Work with veneers quite a bit and I use the spray contact adhesive most of the time.