Recent content by Timthetangent

I've just bust the handle off my cast iron wood guillotine used in my framing workshop. I am looking to replace this and can only see one similar Mitre Trimmer / Moulding Guillotine I mitre mainly hardwoods upcycled from old bits of furniture. Any advice would be most appreciated thanks.

Thanks everyone. I have procured a replacement collet and nut which I may regret as the arthritis gets worse.

Extremely thank you

I've had a couple of router/router tables over the years for my picture framing work. The current model is a Trend 1/2" and has been great to use for the past 5 years. I did relocate last year just before the pandemic and ended up putting everything in storage for longer than I wanted. The...

How is it for dust extraction? I'm told even the best table saws are notorious for spitting at least some dust out, but that's my biggest issue at the moment with the one I have (when it's working - long story - shared elsewhere on here).

4 x doubles and a gang of four on the ceiling. Workshop 18 feet by 9 and inherited from the previous owner (moved in last November). Using just the table saw, one Sonos speaker and an oil-filled radiator just before Christmas, it appeared to trip. On inspecting the consumer unit, neither MCB's...

Please do when you get the time. I made three a couple of years ago - one for myself and another for two other family members. Everything except the base was made from offcuts and scraps of wood found around the workshop and the occasional skip. (I do always ask when rifling through skips and...

I seem to have hijacked my own thread here to one of aches, pains and medical history! My right knee too has a bit of arthritis and it hasn't been the same since I came off my bicycle on the ice about 12 years ago and broke my patella. To get back on thread (almost) the knee so far hasn't...

The update is that I stumbled at the "remove single bolt to release the blade guard". Single bolt elusive. The handbook has the complete parts map and no bolts listed. Attempted to remove one screw (as close to a bolt as I could find) and immediately regretted it. It's sprung so getting it...

It looks rather washed up to me.

Well dad passed 34 years ago Phillemere and the floor got a coat of all white after that. It could probably do with another coat, but the house is now being sold as mum has gone into a care home and it's in a poor state of repair now (long story, but half finished refurbishment by builders who...

My father painted his garage workshop floor for many of the above reasons, but also because it's much easier to sweep a painted surface than a raw concrete one. The dust from the latter is awful. Dad was a notorious miser though, so any old leftover paint would do for him, resulting in a...

Spoilt for choice I reckon, but you're right in regard to some brilliant words being put to mediocre music and vice versa. Cohen has already been mentioned, but the opening lines of "One of us cannot be wrong" always made me smile. "I lit a thin green candle, to make you jealous of me. But the...

Wow. I've never worked with veneers before. Either pre-bought mouldings when I first started, but since then solid wood with a story. Picture frames is pretty much all I do though. I frame my own work, usually the image having a connection to the wood.

Thanks yes. I've been on the computer for too many consecutive days so went for a long walk today to clear out the cobwebs. Back to the saw tomorrow. I'm pretty sure I'll get by with what I've got. I bought a set of brushes too to check and sort if necessary whilst I'm opening it all up...