I originally posted this on another forum but in hindsight I think with the bigger membership here they may be more people who are knowledgable in this
I have my eye on a chest of drawers on ebay, just the right size for where it needs to go. It is an oak veneered carcass and solid...
Exactly this.
No I haven't seen the rollers myself. I do understand how they angle and push the work down and in. They look like lovely bits of kit. If anyone wants to buy them I also have no problem with that, I've bought plenty of stuff cause I wanted it. I am trying to show the OP that...
You are right a spindle moulder is not the tool for cutting a dodo in the middle of a board. Its also not a tool for someone new to woodworking. Router table should work fine but which way were you feeding the workpiece? You can also make some featherboards for nothing to hold the work piece...
I’m not sure epdm glazing tape is suitable for the detail drawn above. My glazed frame is constructed very similarly but we used compriiband which is more suitable to allow for the movement of the frame
Mark
Cant add much more than has already been said but I agree you're going to get a sag and pooling on that roof. Personally I'd redo it properly but the steel could work (I think you'll still get pooling at 2 degrees but it might resist some of the sag). If the old timbers do come off you can...
Ring Mapei, they will tell you which to use.
I have previously diamond grinded the lumps and high spots off my concrete garage floor. Its surprisingly hard work, hiring a dust extractor that can handle the output a must (don't be tempted to use your shop vac, you'll destroy it), and be...
Put a piece of normal paper over the clean filter with the motor running (doesnt need to cover all of it). Switch off the power and note the time it takes for the piece of paper to fall off the filter. Write this time on the side of the unit. Every now and then repeat. When its falling off...