Hello
Probably been asked b4. Can anyone recommend a combination Mig Tig welding machine. The guy at Stahlwerk in the EU won't trade with us anymore but does have one with plasma also.
TP
Anyone know where to get single Vee pulleys blank centres or small hole. I want to reduce a motor 1400 rpm to 350 rpm with 4-1 pulley ratio.
Maybe around a 50mm motor pulley to a 200mm dia driven pulley.
Any advice very greatful.
Taul Paul
Yes 300 is the target. I'm going to have to buy a 1400 rpm motor and pulley that down. 350 actually works as a 4 to 1 reduction so I'll go with that.
Thanks
Does anyone know the actual general wheel RPM on a 4 1/2" angle grinder. I've seen 10 000 mentioned but
I find it hard to believe. Plan is to use one as a motor power source but I can't if it runs at that speed.
TP
Eyup peeps
Probably going to line myself up for a load of criticism but here we go. Bought the old tired Wilson vice a few weeks ago. Just as a keep me busy project. Loved going
thru it and bringing it back to new look life. All the bits to the right of the mic are the old bits that were
made...