Recent content by Stevekane

Thanks for that thought, but I will stick with an egg McMuffin thanks,,,,

Hi Niall, that certainly would make things easier, Ive not done it like that before feeling quite wrongly that its somehow not the way to do it, but hell, its the same result! Steve.

Thats reassuringly good to know Spectric, I dont know the brand my son is using at the moment, hes doing two showers and Im helping, but I recall him saying that they were one of the cheaper brands of cement boards and they have one side pre-primed, he has however slapped on primer anyway.

Really intresting that this topic should pop up as Ive been looking at creating these joints with beaded edge material, obviously I can cut by hand but I might get a neater joint using the router, trouble is that so far I can only find the Kreg router bit,,and its very expensive, I need a 45...

I think that plywood (esp primed with PVA) is frowned upon for showers now, cement backer board (there are cheaper alternatives to Hardibacker) are excellent and cheaper than iffy “marine ply” and many come preprimed, lots of info online. The SDS stuff that Wicks sell is super to work with...

I have an old 110v Fein and like everyone said, its great, its got a very long lead which is soft rubber so no trouble to pack away. By comparison I recently had to use a Lidls multitool and it was truly horrible and seemed to vibrate so much that the blade didn't want to cut! It worked though...

Would it be possible to join each board with substanial loose tounges and assemble as snuggly as you could, perhaps using kitchen worktop bolts?then cut a hole in the middle which could be covered by a cap, as the top shrank the segments could be tapped further in so they are tight again, this...

I was very taken with Phills little inserts above, but to get them to be really strong needs the shape of the joint as well I think? My initial thought was a large dowel but of course lining it up is really difficult and I wondered if he could clean up the joint and use good glue, then once...

Whilst you've all got your compressor heads on could I ask if anyone has looked at the pressure switch and how it might work on one of the little Parkside compressors, I found my sons one doesnt switch off? Steve.

Fully agree with that John, there are some really horrible ones around. Mine are branded up as Michelin and came in a nice bag, there was a guy at the bootsale had a big box of them and was selling them off at a couple of £ a set, he said they were given away with of one of the french car...

Many thanks for this info, my son has a Hitachie drill that he says will not charge, I think its because he has allowed it to sit flat,,so will give it a try. As to Car batteries, Ive found in recent years that connecting up jump leads and trying to start often results in the engine barley...

Just for info and probably not the sort of thing you should ever need to know,,our neighbour wanted to replace a double glazed unit in his conservatory, I had shown him once before how to get them out and was happy to help again, however he pulled it out himself measured and ordered up a new...

Shouldnt you start with a poker, thats what everyone seemed to make at school about 60yrs ago?,,,,mind you we had fires to poke then,,give a kid a poker now and he might brain somone with it! However, based on this ancient and limited knowledge I would more seriously say, I think you wont get...

Re the Microwave questain, its correct to say that its efficiency claim that I read somewhere was probably in relation to warming food and it was just an idle thought that perhaps it could heat central heating water as well as forgotten coffee,,but Im sure your all correct. Intrestingly there is...

I recently read that a microwave oven is apparantly the most efficient way of heating up things,,I wonder if anyone has tried making a microwave powered boiler,,,could it work?