Recent content by spearojosh

Would a simple NVR switch such as this one be simple replacement? https://www.ebay.co.uk/itm/KEDU-NVR-Swi ... SwNMZdlcV8 Thanks again all

I see. I don't have a massive amount of electrical expertise, I'm afraid. Replacing the contactor doesn't seem to difficult though. Does this Danfoss unit look like yours?

Hi fitz, how would you recommend going about remedying this issue? A whole new switch or can you replace the coil alone?

Hi all, I recently acquired a 3 phase 352. I've taken out the old three-phase, 1hp motor and ordered a new 1.5hp, single phase motor. Can anyone tell me if the old switches (pictured) built into the machine will still work? Thanks Josh

Little problem: As soon as the wood clears my infeed rollers, it stops dead. Strange thing is, the outfeed rollers still seem to be touching the wood. They're just spinning on it. If I pull the wood through manually the outfeed rollers drop a little bit when the wood clears them. The outfeed...

I have been running my PT (Sedgwick PT255), table saw and router on my Yorkleen WV2. This is a 2000W twin motor machine similar to the Record DX4000 or the Camvac twin. It handles the waste quite well but after reading the Bill Pentz stuff I am starting to think I should invest in a system with...

Bit too pricey at £250. I don't put a price on my health but I'm not convinced these type offer much more protection than passive masks

@ Rich I think that was my reasoning too. Although I think the 3M 6800 full face masks come with a replaceable film, as per the ones you would put on your phone to prevent the screen from scratching.

I'm about to replace my existing mask. To date I have been using the 3m-4251 and replacing every few months. I'd now like to buy one where I can simply replace the filters when needed. I have been looking at the 3M 6000 range but can't decide between half mask (6300) and full mask (6800). Is...