Recent content by smiley65

Hi its supposed to be 19mm wide and i measured with calipers

i own a axminster ac216ts table saw which has a cast iron top just recently i bought a miter gauge for it only to find out the slots on the table are only 18.60mm not 19mm wide what would be best method of sanding them to make them wider,any good ideas would be welcome

Thanks doug thats the one i was thinking of getting because i have a 12x8 shed and most other units would need a shed on there own

Hi all i have just bought the axminster ac216ts table saw and they say use a 850m3 ph extractor but would a 183m3 ph do the job was looking at the scheppach ha1000

Thanks for replying i have only seen white pine in bq wickes ect but will take another look online

Hi all, i was going to make some garden chairs using pine then stain and then put some kind of weather sealer on it all, is pine ok to use as looking around at prices of other kinds of are to costly

Hi sunnybob thanks for replying,as im not really mech minded should i get a fix i shall ask my son to do it or see if i can find a helpful person to lend a hand as my eye sight is not good,by the way i looked at your pics you are very good at woodwork. :)

Thanks for the replying,i have taken one back already with this issue but much worse the other problem or thing to think of is that these p/t are generic and sold under different brands at much higher prices as much as i can find out this one is very much the same,i had seen a review on screwfix...

Hi all, i have bought a erbaure j/thicknesser from screwfix i have put it together but on checking that the jointer tables are level with each other i found that both infeed and outfeed tables are angled down toward the cutter head,i have contacted screwfix but have had no reply from them on how...

Thanks for that sunnybob i will take your advise

Hi bob,i have been watching some you tube content from different people and they suggest using one when carving wood,and as im trying to learn how to it seemed a good idea thanks for your input

In need of some help im trying to find a variable speed foot pedal for my dremel but all of the ones i have found so far are not uk spec,or costing a fortune which i cant afford to be honest ,any help would be really great,i had found one on ebay but for what ever reason although i had put item...

hi mike thanks for input,when i install the builders paper on inside of shed does it matter if it is touching the outside wall of shed and then 25mm gap for insulation then ply to cover all,also should i add a couple of air vents?

only have enough space for 25mm and that allows a gap of 35mm

back to builders paper and polystyren i think