Recent content by Shane

Thank you, that's good to know, if I have the misfortune to have to use mdf again I'll bear it in mind :)

Not sure, we used 2k filler which I would have thought would be pretty stable. It may be the solvent from the filler trapped underneath in the fibres trying to off-gas after painting, and physically pushing the filler out, but didn't do too much experimenting as I just changed the construction...

For them to get it cheaper they would need to obligate to a certain number from you, if that is possible, and commit to an appropriate payment schedule

In my own experience of spraying mdf, we used mrmdf and pva glued the edges first. We used high build 2k primer, base coat and lacquer, all with proper booth and ventilation etc. All I would warn against with mdf is any filled screw holes will swell, no matter how carefully you fill and...

Blimey, old profile and thread resurrectorino! Is there a Pete Williams in the house? here are those pics you are after, if you need any more info give me a shout 8) Attached to the existing sliding table is the Axminster sliding table designed for the spindle moulder WS1000TA edit: Just...

I'm just a little shocked reading this Sincerest condolences to you David and the rest of your family I had the pleasure of exchanging PM's with Roy regarding his bike project, and was going to make him up a stainless steel exhaust later this year if he needed, looks like that wont be...

Blimey, missed all this, all the best Roy for a steady recovery

TP still stock window sections

What colour is it? if it's black you may get away with blending the corner a little with colourfil

I put a freud blade in mine, cuts well

Thanks John, much appreciated mate, hopefully I'll get the chance to test it this week and see how it goes... 8)

Hi John, Thanks mate, the weight will deffo need adjusting as it hits the pillar base well before 210mm. The sizes I mentioned further up the thread was with regard to the chisel section size, If I need to go much deeper than 70mm I just spin the timber over because of the cutting length of the...

Thanks mate, much appreciated 8) Yes mate it comes with the stand. Only issue I could see with it is that the weight inside the rear pillar is hanging a bit low, therefore restricting its upper most travel. It will be interesting to see how easy it is to access the weight for adjustmest...

It's the same model as this... http://www.ebay.co.uk/itm/Morticer-Mult ... 231b678d73

I can get a pic early next week, it's in another workshop at the mo. I have a multico planer which is a great piece of kit, so I'm sure the morticer will be good as well. It all depends on what it's cutting capacity is, the Axi is 16mm hardwood, 19mm softwood, I'm hoping the multico would be the...