Recent content by Russ G

Evening All, I’ve got an issue with installing drawer runners (bearing) in an old built in wardrobe. The top right of the drawer on both two drawers pops out but the left side fits perfect. I’ve checked for square (fine), ensured both runners level and I’ve been shimming non stop but can’t get...

Thank you very much, I followed the pdf you sent and it took me about five minutes. I think I will send over to rutlands so they can copy it and send out. Again thank you for your time

The one I’m using is as attached: https://www.rutlands.co.uk/sp+power-too ... h=1-2-a=15°-s=1-4-rutlands+tr245#

Thanks But that is not the same but as the Tornado set. Does it matter that they aren’t the same or should I just follow those instructions? Does it matter that I’m using 3/4 material and not 1/2 inch? Thanks again to all for your help

Thanks I’ll need to give it another try on my next day off... thanks for your help.

Thanks again, I looked on the site at the instructions but they are for a different looking but than from that set. Do the instructions work even if a different bit?

Thanks pal, I will have a look at it and see if I can set it up. Was yours the one in the set? Have you made a block template for it and would you like to send me a copy of it if I were to pay?

Afternoon, I’ve purchased a router lock joint bit from rutlands but they don’t give any instructions. I’ve tried looking online but the bits aren’t the same and when I try to follow it still doesn’t work. Has anyone purchased the Tornado drawer and closet set and have you manged to set it up...