Recent content by robsmuddygloves

Cheers, I'll check them out. Any other recommendations?

Hello all, I'm after any recommendations. I recently picked up an old multico dust extractor with 100mm inlet and outlet, that I hope to connect to a thien baffle or cyclone. However, there was no bag with it and was looking for any recommendations. Cheers.

Hi all, I picked up a little CCB perform/Axminster bandsaw the other day for dirt cheap. I need to replace the tyres and was wondering if anyone might know where I could get some. Here’s hoping, Rob.

I'd not seen the one on Ebay. Thanks for the advice. Plenty to ponder. I'll have another chat with him re chucks.

Hi, I'm very keen to start turning and a local guy to me has two lathes he's selling - a scheppach DMT 450 with extended bed and a tyme Avon 48". They are both in good nick, so as a complete beginner which should I go for? As an aside the scheppach is half the price, though that's not...

Cheers. Hopefully I'll get to use it in earnest soon. I need a bigger planer and thicknesser, but as you say this should prove quite handy. It was also cheap, always a bonus.

Cheers! It actually came with a spare new belt. Looks like I’ll be making a guard soon. Plus sharpening the blades. I really appreciate the advice.

Thank you all for the advice. Just checked it and the blade stops within a few seconds. Johnnyb any advice as to what belt I could replace it with?

Thanks for your reply. I can retrofit an NVR, and I’ll definitely house the belt. Many thanks for the advice.

Hi all, I was wondering if anyone could give me some advice. On a whim I picked up a small 4 inch planer off eBay with no make anywhere to be seen, the seller didn’t say much about it. As you can see from the photos it’s housed in a rudimental ply box of sorts. It runs smoothly and weighs a ton...

Thank you all for the information, much appreciated. Looks like a Freud blade it is. Next job, try and do something with the fence...

Hello all, I am a newcomer to the forum and woodworking, as such I would be grateful for some advice. I’ve managed to pick up some cheap second hand tools, some good, and some nasty. One of which is a cheap and nasty Nutool 1500 tablesaw for peanuts. The blade that’s on there is not great...