Rewound's latest activity

I see that 'optimal load' thing now - it will take 2.8mm (horizontally) of material on each pass? on a 7mm mill that would be 40% of...

yep - and it worked the diameters were all 1mm too small, however I think that was because of this setting? I think I now understand...

Single flute compression bit is very good for most sheet stuff and general woodworking. It is all about chip clearance. If you look at...

I'd go pretty much with what Chief Sawdust Maker has said above. A lot will depend upon the machine rigidity and power of the spindle...

they have a laser ccutter which is just fantastic - the only real skill in that table is the leg

at the moment the machine is only used very occasionally and has only been used to cut stuff out and engrave. I think they start off...

thankyou - I will get back to you tonight, off to have a play with it now, try and learn how to position the head and upload the NC - it...

I run a CNC Router pretty much daily in a commercial shop cutting Oak, Ash, Maple, Plywood & Redwood For the majority of my work which...

What's GBT ? If you are going to cut wood, why would you use a 4 flute HSS mill ? Think routers for a minute. No one uses HSS. We use...

firstly its not my machine and this is the cutters I have been told I can use! yep, they are the type of milling cutters I would use on...

Ihave the opportunity to use a CNC router and I am trying to use fusion to create the NC file so (soft wood) for a 7mm HSS 4 flute mill...

as in just dampen them, leave them overnight to dry out then see if they are tight again? or do you mean dampen and glue at the same time?

Thoughts on what glue to use. The tenons have been in an out that many times they are a little slack (just tight enough to stay in...

That would be fantastic to dovetail them in, master cabinet maker skill set a must! I could probably do one, but unable to adjust the...

I have just went back to the methods i have used in the past, stupidly time consuming, think I spent 5 hours today getting the joints...