Recent content by PeteG

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. P

    Which Adhesive?

    I have liked the concrete tops when I've seen them on these TV house renovation type programmes, I think one of the best was a very large centre unit that I'm sure had the sink and hob built in. Not sure it's something I'd tackle myself though. I had planned to replace the tops this year funds...
  2. P

    Which Adhesive?

    I thought of Silicone, but not sure it's the right stuff to use in an area used for baking, kneading dough etc.
  3. P

    Which Adhesive?

    It's on rubber feet, they're not very thick but I was going to remove them so I don't have to remove too much of the worktop...
  4. P

    Which Adhesive?

    More advice than I'd anticipated, so thank you very much to everyone :D ... As Distinterior has said it's a laminate worktop, so I could do with a permanent seal around the Granite. I'm not bothered about removing it to clean, if it's sealed everything should be OK. It's three metre long the...
  5. P

    Which Adhesive?

    I doing a bit of work on the kitchen. A few months back a burnt an area of the worktop, so my plan is to router out and inlay this marble cutting board. What adhesive would you use or would you use something else? Any help would be appreciated :)
  6. P

    latest cuts

    I love the first Tree of Life and the Green Man, very nicely done fella :D
  7. P

    Axminster Trade AT460SS?

    Appreciated whatknot :D
  8. P

    Jet JPT260 Planer/Thicknesser Chip Extractor & OneWay Gauge

    Thankfully, it never sold HovisB, and earlier this year I decided to keep it. Sorry.
  9. P

    Axminster Trade AT460SS?

    The Multicut SE was a wonderful saw to use, never skipped a beat and vibration was minimal at full speed. The only thing I really didn't like was the insert plate not being level with the table, at nearly a grand it should be perfect...
  10. P

    Axminster Trade AT460SS?

    Appreciate the tips, not something I'd have thought of :D It'd take me a few weeks to buy new, a couple of hundred for used, and I'm good to go...
  11. P

    Axminster Trade AT460SS?

    I sent Brian a PM several days ago, but he might be a little busy :) Whatknot :D I read that Axminster had replaced the plastic bushes although like you, I would have been tempted to fit bearings...If you have used a Hegner, does the Axi cut as accurately?
  12. P

    Axminster Trade AT460SS?

    Is this scroll saw still a good buy? I regret having to sell my Hegner a few months back, didn't have a choice at the time. Hopefully things have changed! I've no chance of buying another Multicut SE and can pick the AT460 up for £450.00, as against £586 for the Multicut1...How is the Axminster...
  13. P

    Perform P1400B Bandsaw...Hardwood Test, Max Cutting Depth

    Appreciated Horsee1 :D Having a Dremel makes sanding easier, although it can take longer to sand than it did to cut out...
  14. P

    Perform P1400B Bandsaw...Hardwood Test, Max Cutting Depth

    I thought it might go up not down...If I had the cash I'd buy another just to save changing blades :D
  15. P

    Jet JWSS-18B

    Has anyone had chance to use either of the Jet models? :D
Back
Top