Recent content by Pedro_Hernandez

Thank you all for your advice, youve all been very generouse with your help for a newbie on the forum!. I stopped on till gone 6-30 at School on Friday and I'm pretty sure I established that the mitre slot was parallel to the blade and there was no warp to the blade fitted or evidence of wobble...

Cheers Roy, I use a dial gauge and non digital vernier, with the same process you noted above. There's no wobble on the blade and the blade is parallel. I'm starting to suspect my mitre gauge is the culprit, It look's like it's already been tuned in it's lifetime and on reflection it's not the...

I've already elimated that from the equation Roy, with or without the riving knife the problem still persists. However the arm that the riving knife bolts to has movement up and down on the spindle, is this normal ?. Peter

Hi Yeah the blade is parallel to the mitre slot, I followed the instruction in the original manual to check this. We use TCT blades and thier all square and no tips missing yet the same problem occurs regardles of which blade I try. It would be nice if all I needed was a new blade for a quick...

Good Afternoon I'm having problems getting a square cut on our Wadkin Bursgreen 10" AGS tilting arbour saw at School. I'm baffled as the saw blade is square to the table and the mitre slide is also square to the blade and the fence, which is also square to the table .The saw blade is also...