Hi,
Looking to get a 160mm (ish) track saw blade for cutting down slightly atypical materials... acrylic (3mm, 5mm, 10mm), ACM (3mm) and Foam PVC (10mm). Sometimes these materials will have either printed and laminated self adhesive vinyl applied to the face or be direct UV printed prior to...
OK so is the consensus that an H class vac is overkill even for MDF?
The Nilfisk Alto Aero looks good value but doesn’t seem to have any classification. Nilfisk do seem to do M and H models but they’re considerably more money. Where do I find an Alto Aero with a hepa filter?
Thanks for the replies.
I'm still umming and ahhing about H vs M. Allsaw have said that if we're going to be cutting any MDF then they'd recommend H class but the bags all seem to be M class anyway. We don't use a lot of MDF but there will be the odd bit here and there. I'm thinking H would...
Thanks for the suggestion MikeJhn but I think I’m going to stick with the more traditional route of Starmix, Festool etc
I asked the same questions as I have above to Allsaw who sell the Starmix. I’m not too knowledgable about electrics and to be honest now I’m even more confused.
This was...
First post so hello.
We’ll be getting a Mafell MT55CC track saw shortly. Main use will be cutting Dibond, acrylic and other signage type materials. We want to minimise any dust as much as possible due to other equipment in the environment we’ll be using the saw in so are looking at vacuums...