Recent content by Paddywack

I don't know your situation but if you haven't already done so maybe you should spend money on insulation and then maybe a smaller fire which burns less wood etc etc etc.

If people aren't happy with the way the licence fee is applied why not lobby an MP or write in to the BBC and complain, I haven't seen many posts on here from the Director General so it's hardly likely he will know how unhappy you are. My personnel view is Radio 4 is worth every penny of my...

What? You were 114 ha ha.

I had an operation on my should to remove some bone and calcium and after having it in a sling for a couple of weeks I started some gentle Physio and developed a frozen shoulder, after looking it up on the internet I discovered that it "could" take three years to return to normal, that wasn't a...

Hi Spindle, On holiday now until Xmas so I tried to do it from my iPad so maybe that was the problem so will do it on the Desk Top when I get home. Ps. I followed the instructions but still couldn't do it.

Sorry about the delay with the photos, I have tried but it says the file is too big. It's a normal photo so I don't know why it won't do it.

I know this might sound a daft question but have you got enough electricity coming in?

Mark My Felder was set up the same but like you I now use the sliding table, I have just fitted some Campshure clamps from the States and it takes the scary bits out of using my Table saw for ripping or x cutting. That is some set up on the Wadkin.

I am more confused now than ever, why do I have such a long fence on my table saw, surely the manufacturer doesn't suppose I am only going to do sheet stock and not need a short fence to rip short stock. If I am to slide my big fence back it sticks out in the most awkward place. I am all for...

Hi Bern, Do you have a website for that stove, I googled it and got nothing like it. Thanks

I may be stating the obvious but how many people check the Splitter when they change Blades, not all blades are the same thickness. (homer)

I just measured the run out from the back of my long fence and it is about .5mm not 1mm as I said before, I have never had kickback. I have a sliding table for x cutting and must say that is the best way to x cut on a table saw that I have used. I don't get the short fence for ripping! what...

Oh dear, what a nightmare! Not for the feint hearted, it was more work than I was led to believe but am now an "expert" ha ha. It was all going ok until I realised I didn't have the skill to set it up to the same level as the old Block, but after getting Felder to come out and re commission it...

Well it worked, I did get the HSE involved who confirmed that it was a health hazard and low an behold Felder couldn't get out quick enough and did a very good deal on the travelling fee ie nothing, had to pay for my planer to be re-tuned and I must admit that the service engineer Kevin was...

Hi, Where can I get a copy of the Plans for a Nyle kiln? Do you think a small shipping container would be any good if it was insulated ?