Recent content by OldSchoolTools

So we are on the move to new premises, bigger & better, be sure to keep in touch, Gary OST

Only being an R Whites Lemonade Drinker I couldn't say :) joking a part It probably does and your correct about the cosh, although I do get some literature through woith orders I will check next time, yes it can sting skin a little but nothing that causes myself any harm. just to note Im note...

Hi Andy, I have used over the last 3 years a product called DEOX rust remover, available in a powder solution that you dilute in look warm water and leave for about an hour removes a lot of rust just a little clean with a wire wool, this does not leave any abrasive marks on the steel, it is...

I think a lot of people are in agreeance regarding Makita, they have slipped down the market, I now use Panasonic drills not had a problem yet, do like the Hilti tools but the price doesn't outweigh the use and those thieves out there. I also don't think the Makita batteries are the same as...

Must say they are the best I have used, worth the extra money, these screws can be screwed without the need of a pilot hole and removed again and re-used and the heads will not wear, try saying that about any other screws these days that are on the market once they have been used and removed...

A good material for yacht building used on the handrails also the decking in some cases.

Mmmmm interesting, I know it will be a challenge, think I will need to speak to a couple of old bench hands for advice, I made a model some 28 years ago a college but that has long gone along with the knowledge ha, just thought it would look nice as a piece of furniture, dont expect it to be...

Fancy something different as a focal point for our front room, so Im asking for help and to see if anyone has any plans for either a spiral staicase with balustrade or a revolving door set, type you would use to see in a bank, looking to make something a couple of ft tall any ides would be...

Thanks for sharing, I really enjoyed visiting your site on the process procedure. Gary