Recent content by nibeht

Yes think I will do that periodically, think I only do when\if there is an issue.

Just an update and thanks again. It has worked absolutely fine since last message, so obviously a loose wire initially and then some kind of time out on the being tripped. Have asked Record Power but nothing todate. Thanks again for your offers of help and your ideas. All the best, Graham

Thanks for the good luck wishes, am hoping to do some work on there tomorrow, so hopefully it hasn't changed it's mind again :-).... I did run for 20 minutes cutting various thicknesses and no issues so am hoping it was down to that loose connection. Will talk with Power Record when open...

Hi Fergie, Yes they are lucar type and lucky enough I did what you recommended after finding it disconnected. I also checked the others and they were tight to pull off. many thanks, Graham

Hi All, Well really lost to as what happened. I went to take a look at doing some basic troubleshooting. But initially thought would try power switch again just in case (and Kind of wishful thinking), and it powered up. It worked straight off the bat ? I had done nothing to it since...

Hi Gordon Thank you, your offer is very much appreciated. I have just ordered another switch, as per above response to Ttrees. May I get back to you on this if no joy. Have had another offer of a visit as well so very much appreciate the help and may have to get the coffee, tea and biscuits...

Hi Ttrees, Thank you for input, yes agree I need to look further into and try and eliminate things. I have actually taken the switch out again and one of the connections had come off, not sure if this happened when putting back into machine or when I just took out (again!!), but as a...

Thanks Bingy Man, Yes definitely a case of if no obvious case to replace a part i will have to keep trying to find someone willing to take a look as lack of knowledge is too dangerous :-). I am in rural south lincs and not had much joy with anybody willing to take a look. Thank you Spectric...

HI All, Hope someone can give me some possible solutions to my BS400 issues. The BS400 stopped working recently and I suspected the power switch, this had played up before but a bit of jiggery pockery got it working again. Alas for a few goes only. I have received a new Power switch and...

Thanks Alex will take a look to see if anything happening soonish and then the race starts and we will see if my patience wins or loses :-)

HI Steve, Thanks for that. Unfortunately as I am new to the forum it doesn't let me send\reply PMs at the moment. You are quite right Steve I am total novice to Bandsaw (wood work too) and I ordered the initial DVD as wanted to check out the bits you mentioned about the side blade supports...

Hi Steve and Nic Thank you both very much for the information and advice. I appreciate your coming back on these queries and sorting out my confusion. I had researched the Band saw and then suddenly thought I'd have to start again with Scroll Saws instead but with your advice it looks as...

Hi, I am a total novice so would appreciate any feedback you may have on this. After seeing your posts on here I just wanted to get your feedback on the smaller blades use with a BS400. I spoke with Record Power and they came back with:- Quote It is not advisable to put smaller widths on the...