Recent content by Millcottage

Hi, Looking for a suitable 16A replacement switch [must brake the motor] for an older Elu table saw. The one on it is no longer available. I thought they would be as common as muck since all saws must now have a brake facility built-in. Any help will be appreciated. Thanks.

Thanks, all resolved - not an attachment I'm needing or going to use besides I have no cutters for it.

Thanks. No it is the bottom part of the contraption that slides up and down and has threaded nuts. There is a wee screw that keeps it on and of course allows it to fall off!!

Hello, I have lost the bottom part [the fine tuner] for my drill grinding attachment - a replacement doesn't seem to be available anywhere. Wondering if anyone has such a thing available? Thanks in advance.

Thanks, but unsure how it would work. Somebody must recognise it .... please!

Brilliant, thanks.

Hello again, I was warned that this website was seriously good! Within a few hours I have a solution offered - just need to now find the part that you advise is no longer available! I was thinking that chuck arbours can now be got with a hex shaft on one end and a 3/8" x 24 UNF on the other...

Hello folks. Got hold of this drill guide recently but notice that the drill connection end is threaded. Any ideas or advice on how to attach a drill to it? The other end is also threaded - a female end so I assume a chuck is screwed in there

Hello folks. Got hold of this drill guide recently but notice that the drill connection end is threaded. Any ideas or advice on how to attach a drill to it? The other end is also threaded - a female end so I assume a chuck is screwed in there.

Can anyone identify this please?