micky L

Thank you for your help much appreciated and yes it was m 2nd attempt post I had not seen the replies the 1st time 🤓

Cap iron has to go on the flat side of the blade. When the blade and cap iron are inserted, the cap iron has to be uppermost. Simple...

https://www.ukworkshop.co.uk/threads/bevel-up-or-bevel-down.145081/#post-1697577 So much pondering that this is the second thread on it?

Bevel down for the smoother and bevel up for the block plane.

Yes my friend it very catching to have and use good kit 👍😊

Recently, i have splashed out on a Kapex KS60, a large axminster chipping extractor WITH the fine filter drum. The Axminster craft...

Thank you for your help everyone says the same 😊

On a standard plane bevel down on a black plane it will be bevel up

Thank you for your help 😊

I’ve always struggled with this but these pics are from a book I use for reference - I’m no expert by any means and the book is American...

Thank you for your help 😊😊

One of the simple tricks that works 99% of the time is that, when the cutting iron/blade is properly in place, you can read the...

Could someone tell me which is right to which way the bevel should be on a smoothing plane ? And a block plane please I ve always...

I’m never sure about which way the bevel on a smooth plane sh be. Also a block plane ? Any advice welcome thank you

Hi again I was just wondering if you had made any decisions yet on your tools as you know I’m very keen