Hi,
For an upcoming project I’ve got to fit a 4’ jointed panel in a circular frame that will be hung on a wall. The grain of the panel will be running up and down so I expect movement to be sideways.
the design calls for a tongue fitting in a groove in the panel with a small reveal.
if I just...
Hi,
Thanks for the reply. I should have explained better. The bearing was one of the guide bearings not a wheel bearing. Although I do think the issue is mechanical rather than just a normal bandsaw tracking one. Still scratching my head.
Thanks again
Mark
Hi,
First post so I hope I've put this in the right place.
Problems with a Record RSBS14 bandsaw. I know it's a light weight machine but I've always tuned and maintained it and regularly use it to re-saw up to it's full capacity.... until today!!
Cutting some curves I heard a loud bang from...