Recent content by LostOZ

Ok, the Axminster miter gauge arrived today and, well it is not 13mm as stated, as my slot is 12mm and that’s measures with a digital gauge. that is 8 at the top and 11 at the widest. If I invert it (as Goose would say) it is a bit slack in the slot, but I can make that up, but then a couple...

I have purchased one of these to see if a bit of filing may give me the level of fit I want. I will update when I have it and see if I can work it out. I do, need to buy a top of the range mitre gauge to see the bolt sizes and fittings, to see if I can marry the two into one 12mm...

I have used a piece of exterior cladding sawn down then sanded it to the final width. This is now fine for my crosscut sled, as there are two of them, but again it has a bit to much slop for a mitre gauge, as the thickness is smaller than the depth of the t-slot in the Rojec saw table. The...

I purchased a Rojek euro5 table saw, and after purchasing a slide to build a crosscut sledge, I fine the slider is not 17mm wide but 12mm wide, thus I cut my own parts to fit into the slides and then finished off my sledge. However, I would like a mitre gauge so I can do small angles cuts...

I find there is a lot of similarities between the product set both sell, and I would suspect they are rebadged from another suppiler. However I do find you have to look at the cost as there look the same but are not priced the same.

There is two bits to this, the first is if the vehicle was not there the content could not be shared, and the second and the part the first point relies upon is the content. Both need funding to allow growth, this google allow free access, but you have to put up with adverts, and the content...

My local lidi was out of the bandsaws, so went to the next closest and they had two, speaking to staff they said they had three bandsaws delivered. Used it on a project and worked well on the rounding off corners on 18mm ply

Sorry, but nothing in life is free. If you are not paying the vendor then you are the revenue stream. YouTube users upload more than 500 hours of fresh video per minute, YouTube revealed at recent press events. That works out to 30,000 hours of new content per hour, and 720,000 hours of new...

Cheers, this helps, I will keep looking for a manual, but the parts list shows how it goes together, so a big thanks.

Hi, anyone have a manual for a Rojek Euro 5 Table Saw, I have just purchased one second hand, sorry lovingly pre-owned, and would like a manual, can be a photocopy and happy to pay postage or send it electrionically.

This is one place that looks like I need to visit and then start stocking up, thanks for the share

Yes, I did the whole found floor of my house in grade a (no knots) about 15 years ago and sand it every four years and are oil and still lovely. Would like to do the up stairs, but as it is stud walls I would want to remove all the walls and lay the food and then rebuild the walls, but wife is...

Looking for maple and cherry, or a similar coloured wood, for a coffee table for my den

I have e a few projects I want to start. I have finished my workshop and are ready to move to the next level of project. However trying to find places to buy different hardwoods is proving to be difficult. The few I have found online are only oak or American white oak. Any suggestions or is...