Yh I thought this but with an RCD tripping on earth fault I wanted to give it a try.
I have previously checked the supply cabling and starter to the motor connection box which all worked as expected.
The Garage is fed from the RCD protected side of my distribution board via a 32A MCB. Then the sockets in the garage are fed from a 16A MCB.
All 3 of the above are tripping.
I have recently bought a TSPP250 table saw off eBay.
The table saw trips my RCD when I turn it on.
The existing capacitor says it’s 20uf. I measured it as 10uf. So I installed a new one.
The table saw still trips out.
After reading the above from @guineafowl21 I swapped the positive and...