Thank you!
I am getting the hand of planing I think but I am struggling to set my plane. Its always takes too much off or nothing. I've got a handy jig for sharpening the blade but when it goes back into the block that's when the real trouble starts for me. Poco a Poco I'll get there.
Yes I did think they were a bit chunky and maybe it'd be a lot simpler and possibly even, dare I say it, easier with some thinner wood. I find lots of thinner tails look nicer but I guess one or two big ones might be stronger? Not sure. The biggest pain in the buttocks so far has definitely been...
As a first try I'm happy to stop here. Learned about rabbets and milling and feel this was a good practice project to learn some basics. On to the next one!!
I'm just going to felt the insides and leave it as is so I can look at it in years to come as a memory and to gauge progress.
@Derek Cohen (Perth Oz) as a learner I agree with you that all these power tools take away the ability to properly learn stuff. I was explaining what I've learned about dovetails so far to my better half and she said 'cant you just buy a tool that does it'. By the time I had said "yes but....'...
https://www.amazon.co.uk/dp/B08B8SXK1B/ref=cm_sw_r_cp_apa_glt_i_21Z81DGTZ1M0RQY4R4ZF
Some multi measuring dovetail angle finding hole driller thing....
... Looks cool to me. Anyone had it?
Wait... Cancel that.
Wasn't hammering just pushing. Maybe this wood isn't as forgiving as I though :'( oh well. Back to the start!
Actually sod it I'm gonna get the glue out and see if it will survive.
Hahahaha. That made me chuckle. Yes so I've done one pin side and one tail side for the sides and hopefully if I don't mess it up then the face and back will be 1 tailboard and 1 pin.... I think.
Also I wanted to take a bit more off the bottom of one of them for a tighter fit but genuinely I cannot get them to unlock now. Not sure if that's a good sign or not.
(Edit) got it off now.
Ive come across yet another thing that is confuddling me now. This is my first attempt at doing the...