I use a hand made push block, shaped a bit like a hand plane with a long notch, only for small skinny bits up against the fence with JUST the necessary amount of knife exposed
...tho 98% of the time I use those £1 orange grippy gloves...available from most sheds and pound shops.
Jim
How about using full extension Accuride style (bearing) runners? These could be set in a slight rebate to keep the frame close to the wall. If the wall was a bit lumpy, you could use a frame on top of a frame with a design detail to conceal any join. A frame with a large back bevel would best...
You say AIR...However, I bought a cordless Hitachi (NR90GC2) GAS nailer for a project this summer and it's been great. I'll be selling it soon when the project's done. PM me if you (or anyone else) are interested.*
Jim
* MODs - Apologies if I've broken any forum rules - Feel free to delete/edit
+1 for the Tool Station LED's on 3M sticky back or clips.
A point to note or look out for - and it may of been a one off batch problem - Last time I purchased some 300mm strips the heat shrink join at the LED strip to cable had been over-heated and melted the cables - easy to miss and a...
Thanks for the feedback guys, I hadn't considered a counter weight as an option :D
To make things clearer, attached is a sketch of the original proposed design (with a fixed mirror!), it may appear a little unusual but the customer has special requirements regarding storage and the mirror is...
Hi Folks,
I've been asked to design a 'Cheval' mirror. The customer would like to be able to adjust the pitch of the mirror.
I've been Googling away but to not much joy. Can anybody kindly recommend hardware or an attractive DIY method?
It would be great if I could adjust the friction as...
The Mirka hose and connector is exactly the same as the Festool design (sans the green highlight on the hose) the hose is even tapered so I suspect it's made in the same factory but sold for a third of the price...an advantage over the Festool design is the rubber connector can be easily screwed...
Out of interest, How did they fail?
I've manage to tweak the unit by opening some holes in the circuit board to slide/ move the sensors back.
Cheers Jim
Thanks chaps,
I've checked it across a couple of measures and some rules. Unfortunately it appears to be -2mm, perhaps I could crosscut it? :D
Mildly irritating but the error is constant as rhossydd says, so I could live with it.
I was suprised the manual has no mention of a tweak in the...
Picked up a laser measure the other day from Aldi, it's a nice little tool, but ... it's consistently +2mm out (manual tolerance is +/- 1.5mm). Trawled internet for an extended manual and even had a sneaky peak inside to see if I could calibrate it myself by moving the laser unit.
Does anyone...