Recent content by JamesP7

Hi, the slots are odd, they are just a hair over 15mm (2nd image) I ended up buying some 15mm wide smooth edge Pine strip for the runners on my cross cut jig, although its not hardwood this seems to be working well and hasn't suffered from swelling for just over a year - IIRC I had to...

Ok so it seems to be working at the moment! - I have had a response from Axminster and it is very similar to what you have said above - "the two nuts lock up against the inside of the casing, they have undone and are no longer keeping that bar under tension hence causing it to flip out the hole...

Just had another look today. After trying the washer and nuts on the other side of the arbor/trunnion, I'm fairly certain the washer and 2 nuts are the correct side due to there being a surface for the washer to press up against on the one side. Here are some more photos: By the looks of it the...

Ok, I appreciate the advice - hopefully Axminster will respond to my enquiry too! - Thanks again

Thanks for the reply! - Looking at page 32 of the manual, number 6 on the parts list is a pin - there doesn't seem to be a hole for one on the end of the threaded bar on mine

I have been having some issues with the alignment of my table saw and have run into an issue with the height adjustment. I am unsure on the position of the 2 nuts on the height adjusting threaded bar - where should they be on the threaded bar. From what I understand the end of the height...