I have this router and find the plunge pressure is too strong for pleasant use. Because of this the tool is not used very often. Has anyone overcome this problem?
I would suggest a brush cutter with a blade this will be the easiest solution and make short work of even a large area. Perhaps hire one if it will be a one off use. In my opinion bull bars are essential for ease of use.
I am sure many of us can remember the Experts predicting we were about to enter another ice age a good few years ago. That has not yet happened to state the obvious!
We seem to have had less volcanic activity latley, It could be the lack of the ash in the air has allowed a little extra warming?
It would be worth checking for a stress crack in the blue barrel they are not always easy to spot. I recently had one in a 18 month old water butt which was supported on a slab, could see no reason for it. This crack was on the edge at the bottom.
I had the original pattern for many years unfortunately the back spring became worn and the knife would open in my pocket. I tried the lifetime warranty but the USA refer me to the UK and they said it did not apply here. I would be very happy to buy a replacement part but could not find one...
We had our container Spray Foamed onto the steel and it has worked out well. It could be done drilling holes just like a cavity wall as a last resort but you look to have done a tidy job and I suspect it will settle down :)
Have a read of this article The ultimate guide to shipping container condensation treatments
When your dehumidifier arrives run it 24hrs a day and try turning off your heating. The less temperature difference the lower the condensation. Fit a min max thermometer with humidity reading so you...
I would put a dehumidifier in your box working 24 hours a day and reduce the heating temperature to about 12 degC they are cheap to run. Turn the heating up when you are in there working. We run a CNC and SLS printers in a similar way the weather has been very humid recently.
We have taken to using plastic stock board for roofs it is quite heavy we normally screw two 4 x 2 along the long length. This stops it blowing off but can be lifted off for cleaning.
We also use electrified netting only had the fox in once when the horses took the fence down in 5 years
If you have overpaid by direct debit I believe your bank should immediately refund this payment under the guarantee scheme. Although your supply will be maintained when your company goes into liquidation the new company appointed is not bound to supply you at the same price. Whether the new...