I forgot to say that when using it on a bench (as in photo)... you can use a single cut file to draw file the heavy nicks out. To do this, you hold the file at 90 degrees to the knives and stroke down the length, applying even downward pressure. Using a file this way will quickly remove the...
This was my solution for my Dewalt Planer. I cut 2 slots into MFD at the angle marked on the end (for future reference). The slots are a tight fit when I insert the blades. I then set the unit on the bench (as seen in photo), then use a diamond honing stone stroking down the length resharpening...
Pgrbff,
I have done this several times... and found this cobalt bit to be the best at a reasonable cost. I make a plywood guide with pre drilled holes to clamp the blade (on a drill press) with another piece of plywood under the blade. make sure it is clamped tight to the drill press table...
Other things necessary are a Lead rope to surround the joint when pouring the melted lead, and a lead pouring pot and burner to melt the lead. and also "oakum" (which is the packing gasket material) and a oakum chisel (which is a flat ended slightly curved and has a dog leg in the length) to...
Paul Sellers has been gracious enough to include the pdf plans to his router plane along to a very detailed video. Can't wait for part 2 video. He has included the depth adjustment that makes his router plane compete with the best of the manufactured hand router planes. He has also prototyped...
I would remove the fence and investigate. A good chance it was removed before and not re-installed correctly. Look for the simple things that may have been missed first. It may help to post the model of your saw to get a better response.