Recent content by ddichiera

Oh Misterfish, you've done it again. I have the guard but I have no idea how it's going to work. Might I trouble you for a photo of the mod?

They are great photos and measurements. The difference in diameter between the inner and outer flanges intrigues me (it's what confused me at first). I would have thought that ideally they should match, (as per the originals) in order to maximise grip on the blades, but I guess not. Thanks...

That would be the Bee's Knees :-) This topic has been raised so many times, I'm sure others would also appreciate it. Thanks.

misterfish Thanks, since my last post I found another of your excellent photos on this post elu-radial-arm-saw-t34870.html after which the penny dropped. Helpfully you also gave the width as 28mm and 16mm. In the absence of finding one on eBay, I don't see why I couldn't just have one machined...

Thanks for your replies. misterfish, you photo is very enlightening. May I ask the following questions: 1. Are the flange and bush shown in the correct orientation except the flange should be on the left and bush on the right? 2. Is there a recess in the flange to accept the smaller...

Hi everyone, my first post here, although I have done some searching on the forum. I have a practical question about the use of Dado and Groover sets on machines. I have two saws, a Scheppach 4010 table saw (aly table), an Elu 1251 (e.g. Dewalt 720) Radial Arm Saw and I also have a 16mm bore...