Recent content by Daz01246

I have a propane space heater in my garage. Gets it nice and toasty.

The Trend T10 router has a plunge depth of 80mm. Most routers are around the 50mm mark. I bought one to do my doors with. Not cheap, but bloody good. As others have said, multiple passes will be required in any cuts as deep as that. If you've never used a router before, watch a few videos on...

I've got the erbauer saw. More than happy with it. Good cut capacity double bevel and accurate angle cuts (ignore the laser). Downside, it's bloody heavy, but I use it in my work shop.

Thanks for the replies. I've attached some pics. I made the work bench a few years ago. Next project was my AV unit. I made a cat shelter for my daughter as well as a storage unit for garden stuff. Also, I made a drinks cabinet out of rough sawn oak. As you can see, I will have a go at making...

Hi, I've got a Charnwood W015 cast iron router table. It's pretty good, but the fence leaves a lot to be desired. It's all over the place. I wondered if anyone knew of a way of upgrading it to a better fence. I've looked online, but can't seem to find anything that will fit. Charnwood are no help.

Hi all, been watching for a while and thought I'd join. My name is Daz, I'm from Derbyshire and love my woodwork! Just invested in an Axminster (Harvey) ST254LTS. Previously I had a Charnwood W619, although it served me well, the difference between them is night and day.